OSCAT Forum

network.lib => Codesys 2 => Thema gestartet von: domocla am 14. September 2017, 19:01:18

Titel: Wago PFC200: KNX module
Beitrag von: domocla am 14. September 2017, 19:01:18

Hi there,
I am working on integrattion of KNX bus with a Wago PFC200. All the procedure is clear but I need a to clearify a doubt.

In case I would like to send always a bit telegram value a "0" and not a toggle how can do that? In the FB for a switch there is only a xSwitch_IN. If there's a rising edge of the signal wago send a "1" in KNX system and it send "0" when the signal goes low.

But I would like send always "0" to KNX bus. Could you help me please?

Thanks.

Titel: Re: Wago PFC200: KNX module
Beitrag von: Maxeyejoe am 20. Dezember 2018, 06:14:52

A good website and then make up the majority of visitors come here specially.