Autor Thema: Wago PFC200: KNX module  (Gelesen 3709 mal)

0 Mitglieder und 1 Gast betrachten dieses Thema.

Offline domocla

  • Newbie
  • *
  • Beiträge: 2
    • Profil anzeigen
    • E-Mail
Wago PFC200: KNX module
« am: 14. September 2017, 19:01:18 »
Hi there,
I am working on integrattion of KNX bus with a Wago PFC200. All the procedure is clear but I need a to clearify a doubt.

In case I would like to send always a bit telegram value a "0" and not a toggle how can do that? In the FB for a switch there is only a xSwitch_IN. If there's a rising edge of the signal wago send a "1" in KNX system and it send "0" when the signal goes low.

But I would like send always "0" to KNX bus. Could you help me please?

Thanks.

Offline Maxeyejoe

  • Newbie
  • *
  • Beiträge: 2
    • Profil anzeigen
    • sbo
Re: Wago PFC200: KNX module
« Antwort #1 am: 20. Dezember 2018, 06:14:52 »
A good website and then make up the majority of visitors come here specially.